Genesis machine jammed / strike which was not caused by the ignition system, then we are obliged to check the fuel system, began to see the fuel pressure or injector electrical system.
Checking electrical injector should we do use a volt meter or oscilloscope can also, for the more easily we can use avometer. How to check the injector consists of:
* Check the voltage on the injector. To source voltage at the injectors when the engine dies must be scrolled with Batrei voltage, when the injector On the opposite voltage source voltage (Control of ecu) must not exceed 0.4 volts. If the normal stress and the injector is not working should be maximum injector needs to be replaced.
* Check for obstacles in his / impedance injector. Another way to measure the internal resistance using ohm meter injector, this way we can easily measure the resistance of each injector, usually 3 to 5 ohms for low impedance injectors, or 12 to 17 ohms to high impedance injectors. If the injector resistance should exceed that of the injector needs to be replaced. Do check the injector as cold and heat, if the conditions increase the heat resistance of the injector, you should replace the injector.
Tidak ada komentar:
Posting Komentar